Naren Electronics Company
Manual Control Battery Charger

Manual Control Battery Charger

Send Inquiry

On an aim to encounter the necessities of clients, we are engaged in offering an optimum quality Manual Control Battery Charger. These chargers are manufactured by making use of the finest quality metals and components with input power supply of 230V AC, which can be plugged to the standard normal mains available. Our offered range of Manual Control Battery Charger made available in various specifications so as to suit the requirements of the clients.


Measuring Instruments

  • D.C. Voltmeter to read out out D.C. Voltage
  • D.C. Ammeter to read charging D.C. current

Indication by L.E.D.

  • Mains On
  • Charging
  • Over Charge Cut off
  • Dynamo On


  • Over charge protection to restrict the over charging of the BAttery.
  • Series choke to restrict high pulsating current to continuous current which increase the life of the battery.
  • Input & output fuses to protect against short circuits
  • Output M.C.B to protect against continuous overload.


  • Selection switch to select Boost and Trickle mode to charge the battery in high and low current mode respectively.
  • Over voltage cut off pot to adjust the cut off voltage.
  • Mains ON and OFF switch
Dynamo interlock to cut off the charger from the circuit when engine is running and battery is charging through dynamo (Applicable in D.G. Sets only)


Input Supply

230V 10% 50Hz AC supply

Output Voltage

12V 24V 48 Volts D.C

Output Current

6A 10A or 20 Amps D.C

Over Charge Cut off

90 to 120%

Current Control

Boost Charging (it is normally 14% of 10hr capacity of the battery) Float (it is normally 7% of 10hr capacity of the battery)


H-230, Width-310, Depth-270

Ambient Temperature

0-50o Celcius